Industrial Modem MIU56 User Guide
#O1 |
| Disconnects if terminal buffer overflows |
#O2 |
| Disconnects if line buffer overflows |
#O3 |
| Disconnects if either buffer overflows |
#PIN=n |
| Pin Number where n is the pin number |
#R0 |
| Remote Control Mode |
#V0 |
| Command and S Register verifier off |
#V1 | | Command and S Register verifier on |
%B0 | | S0=0 setting after AT&F |
%B1 |
| S0=2 setting after AT&F |
%C0 |
| Compression disabled |
%C1 |
| MNP 5 compression enabled |
%C2 |
| V.42bis data compression enabled |
%C3 | | V.42bis data compression enabled with fallback to MNP 5 |
%Dn |
| Set disconnect delay to n seconds (default %D0) |
%E0 |
| Disable |
%E1 | | Enable |
%E2 |
| Automatic Speed Stepping |
%H0 | | Use B setting for initial MNP 10 connection speed |
%H1 |
| Initial connection is made at 1200 bps (MNP 10) |
%H2 |
| Initial connection is made at 4800 bps (MNP 10) |
%H3 |
| Initial connection is made at 9600 bps (MNP 10) |
%H9 |
| Use B setting for connection but do not upshift (MNP 10) |
%K0 | | CTS operates normally |
%K1 |
| CTS off during dial and handshake |
%L0 |
| Report current received signal level |
%Ln |
| Set transmit level (n=11 to 19; |
%M0 | | Mode LEDs indicate connection speed |
%M1 |
| Mode LEDs indicate line quality, V.42/MNP errors & flow ctrl |
%N0 | | Standard Baud Rates |
%N1 |
| Standard to 14400 then 20800, 31200, 41600 and 62400 |
%N2 |
| Standard to 38400 then 51200 |
%P0 | | CONNECT message appears before DCD asserted |
%P1 |
| CONNECT message appears after DCD asserted |
%Q |
| Report current line quality (EQM) (0=perfect) |
%R0 | | &R command determines state of CTS |
%R1 |
| CTS always follows RTS (not reset by &F) |
%R2 |
| CTS follows DTR when offline (not reset by &F) |
%S0 | | DSR is not overridden |
%S1 |
| DSR mimics the state of DTR (not reset by &F) |
%T0 | | DCD always follows state of carrier |
%T1 |
| DCD is always high (not reset by &F) |
%U0 | | Standard error correction response codes |
%U1 |
| V.42 response codes when V.42 connection established |
%U2 |
| V.42 response codes for V.42 connections, MNP 2,4,10 compression |
%W0 | | Disable welcome message |
%W1 |
| Send message specified by *W to remote modem after connect |
\A0 |
| MNP block size = 64 |
\A1 |
| MNP block size = 128 |
\A2 |
| MNP block size = 192 |
\A3 | | MNP block size = 256 |
\Bn |
| Send Break sequence to remote modem (default \B3) |
MIU56Robert Way | Page 16 | 2/28/2003 |
