Telex operating instructions System Power, Initial BP-1002/BP-2002 Setup

OPERATION

SYSTEM POWER

The BP-2002 belt pack receives power externally, in one of two ways:

•Via the intercom channel.

•Via the local-power (pin 2) of the intercom channel connector

The BP-1002 belt pack receives power externally, via the intercom channel.

Both the BP-1002 and BP-2002 will pass system power through to subsequent belt packs that are “daisy chained” together.

INITIAL BP-1002/BP-2002 SETUP

The channel termination is initially set for balanced operation, which is compatible with other Audiocom® equipment. If the unit is going to be connected to Clear- Com equipment, one switch and several jumpers must be changed as described in the section on Clear-Com Setup in this manual.

The headset microphone type is initially set for single- ended dynamic operation. To change the microphone type to balanced dynamic, refer to Table 2 for the position of JP9.

5