To remove the Xvhg grid hinge, grasp the locking-pin knob and pull out while applying pressure on the hinge to slide the hinge base toward the long cutout at the end of the track. The hinge base will come out of the track once it is aligned with the cutout. For added safety, the locking pin has a special shape that engages with the track to prevent it from vibrating out of the track hole during use. If the locking-pin knob seems difficult to pull out when removing the hinge, wiggle the hinge base while pulling out on the knob. When the hinge locking pin is centered in the track hole, the pin will easily release.
Xvhl Linking Hinge: Two Xvhl linking hinges are used to link a pair of
An Xvhl linking hinge must be installed in the top and bottom enclosures simultaneously. The linking hinges must be installed with the hinge bases located at the outside of the track towards the sides of the enclosure as shown in Figure 5 with the locking pins on the fittings located next to the sides of the enclosure.
To install an Xvhl into the track of a pair of enclosures stacked one on top of the other, grasp both of the hinge bases and firmly insert both of the hinge bases simultaneously into the long cutouts in the track of both enclosures, pressing in until both
Then apply pressure to slide the hinge bases sideways towards the end of the track until both
ALWAYS CHECK TO MAKE SURE THAT THE LINKING HINGE BASES ARE INSTALLED IN THE CORRECT ORIENTATION WITH THE HINGES AT THE OUTSIDE EDGES OF THE TRACK. ALWAYS CHECK TO MAKE SURE THE LINKING HINGE BASES ARE SECURELY LOCKED INTO THE TRACK, AND THAT THE LOCKING PINS ARE FULLY ENGAGED IN THE TRACK BEFORE LIFTING ANY LOUDSPEAKER ENCLOSURES OVERHEAD.
To remove the Xvhl linking hinge, grasp both of the
Xvhp
12 |