ZEPHYR XPORT USER’S GUIDE
6.Note the standoff near JP 11 and headers JP6, JP7, and JP12 et al. Remove the screw (and washer) from the standoff.
7.Plug in and fasten the ISDN card in as follows (see below):
•Orient the Xport circuit board so that the rear panel is to your left.
•Orient the ISDN option board so that the sockets labeled JP1, JP2 and JP4 are away from you and facing down.
•With the ISDN card angled up so that you can see, make a preliminary alignment of sockets JP1, JP2 and JP4 of the isdn board to headers JP12, JP7 and JP6 on the motherboard, respectively (see below).
You may need to push the leads to the power supply down and out of the way. Now tilt the board down level and push down the board down onto headers JP12, JP7, and JP6.
•Push down
above socket JP3 of the ISDN card firmly, seating it with header JP 11 on the motherboard. You should feel the ISDN card snap into place.
•Replace the screw and washer removed in step 6, above, to lock the ISND card in place. Tighten with moderate pressure.
8.Re- attach the green wire removed in step 5 to the power entry module.
9.Carefully align the front edges of the circuit board with the lower pair of grooves on the inside of the case, and carefully slide the circuit board into the chassis. If you encounter resistance, remove the board, check the alignment, and repeat.
10.Replace the 6 screws removed in step 3
11.Replace the bumper removed in step 2.
12.To configure and test your ISDN Xport please refer to Section 3.4
