Telular SX6P-300G, SX6P GSM user manual Location and Setup, Connect the Handset, Battery Operation

Battery Operation

The SX6P will recharge its battery pack when connected to AC power. If AC power is interrupted, the SX6P will continue to operate, using power from the battery. (Standby and talk-times will vary based upon phone usage during power interruption.)

Location and Setup

The SX6P comes with a standard spike antenna (TNC).

NOTE: The supplied antenna will support either 850/1900 MHz or 900/1800 MHz frequincies, as specified by your wirless service network provider.

1.Attach and finger-tighten the antenna - see Figure 4. Do not over-tighten the antenna.

2.Select a location that is above ground and as close to windows (or exterior walls) as possible to get the best signal - see Figure 5.

Figure 4 - Attach the antenna. Figure 5 - SX6P location.

Connect the Handset

Before you can use the SX6P, you must connect the handset cable.

1.Connect the handset cable to the phone jack - see Figure 6.

2.Connect the handset cable to the handset - see Figure 6.

Phone jack

Handset cable

			Handset
	Figure 6– SX6P handset connection.
Phonecell® SX6P GSM		2		User Manual