![](/images/new-backgrounds/1129873/12987341x1.webp)
3M™ Digital WallDisplay
Digital Markers and Eraser
Assembling Digital Markers
The 3M Digital WallDisplay recognizes
To prepare the digital markers:
1.Unscrew the end cap on the marker sleeve, turning it counterclockwise. Insert two coin batteries (CR2032), with the positive (+) side up. Screw the end cap back on, clockwise.
2.Press the ridged release button on the side of the marker sleeve, beneath the clip, to open the marker compartment.
These batteries contain lithium. Consult your local hazardous
CAUTION waste regulations and dispose of these batteries in the proper manner.
3.Remove the cap from a
Note: The eBeam Software detects the color of the marker sleeve, not the color of the marker inside it, unless specifically changed. Normal pressure on the marker as you write on the 3M Digital WallDisplay screen sends a “writing” signal in that sleeve’s designated color.
4.Cap the marker sleeve to keep the marker tip from drying out, just as you would with any other type of marker. The cap also prevents sending signals when not in use.
5.Repeat steps 1 through 4 for all other marker sleeves.
Note: The signal transmitter in the digital sleeve is located just behind the tip of the marker. Grasp the sleeve by the main barrel so your fingers will not block the signal.
© 3 M 2003. All Rights Reserved. | 21 |