Texas Instruments TPS62065 specifications Enable Jumpers/Switches TPS62067EVM

www.ti.com Connector and Test Point Descriptions

4.1.9J16 VOUT (SMA)

This SMA connector is connected to the output voltage of the TPS62065. It can be used to easily analyze the noise spectrum of the output voltage with a spectrum analyzer. By default, J16 is not assembled on the EVM.

4.2Enable Jumpers/Switches: TPS62067EVM

4.2.1J20 VIN

This header is the positive connection to the input power supply. The power supply must be connected between J10 and J12 (GND). The leads to the input supply should be twisted and kept as short as possible. The input voltage must be between 3.0 V and 6.0 V.

4.2.2J21 S+/S–

J21 S+/S– are the sense connections for the converter input. Connect a voltmeter, or the sense connection of a power supply or an oscilloscope, to this header.

4.2.3J22 GND

This header is the return connection to the input power supply. Connect the power supply between J22 and J20 (VIN). The leads to the input supply should be twisted and kept as short as possible. The input voltage must be between 3.0 V and 6.0 V.

4.2.4J23 VOUT

This header is the positive output of the step-down converter. The output voltage of the TPS62067 is adjustable with the feedback resistors R20 and R21. On the EVM, the output voltage is set to 3.3 V by default.

NOTE: There is a feed-forward capacitor required. Refer to the TPS6206x data sheet (SLVS833) for detailed information.

4.2.5J24 S+/S–

J24 S+/S– are the sense connections for the converter output. Connect a voltmeter, or the sense connection of an electronic load or an oscilloscope, to this header.

4.2.6J25 GND

J25 is the return connection of the converter. A load can be connected between J25and J23 (VOUT). The converter is capable of a load up to 2,000 mA load current.

4.2.7J26 PG

PG (Power Good) is an open-drain output. A 1-MΩ pull-up resistor is connected between VIN and PG. This circuit is active once the device is enabled. It is driven by an internal comparatir that is connected to the FB voltage. The PG output provides a high-level output once the FB voltage reaches 95% of its nominal value. The PG output provides a low-level output when the FB voltage falls below 90% of its nominal value.

NOTE: This function is only available on the TPS62067EVM.

SLVU364 –March 2010	TPS62065/67EVM	5
Submit Documentation Feedback

Copyright © 2010, Texas Instruments Incorporated