PRG Professional Ranges Care and Use | SECTION ONE: General Safety Instructions |
SAFETY
Electrical Requirements and Grounding Instructions
PLEASE READ
CAREFULLY
All-Gas Models:
PRG304, PRG364GD, PRG364GL, PRG366, PRG484GG, PRG486GD, PRG486GL
120 volts, 60 Hz., 20 Amp electrical circuit required.
FOR PERSONAL SAFE- TY, THIS APPLIANCE MUST BE CONNECTED TO A PROPERLY GROUNDED AND PO- LARIZED ELECTRICAL POWER SUPPLY.
See Installation Instructions for electrical requirements and grounding instructions.
CAUTION - ALL MODELS
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND OR NEUTRAL) PRONG FROM THE POWER CORD PLUG
It is the personal responsibility and obligation of you, the user, to have this appliance connected to the electrical power supply in accordance with the National Electrical Code and/or applicable local codes and ordinances by a qualified electrician.
ALWAYS DISCONNECT THE ELECTRICAL PLUG FROM THE WALL RECEPTACLE BEFORE SERVICING THIS UNIT.
It is recommended that a dedicated circuit servicing this appliance be provided.
CAUTION - ALL MODELS
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5 minutes for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners manually, carefully hold a lighted match to the burner ports and turn the gas control knob to HI. During a power failure you can use the cooktop burners, but each must be lit with a match.
DO NOT attempt to light the two left burners manually. These burners are equipped with the ExtraLow® feature and cannot be lit manually.
NOTE: For PRG
Page 3
