Step 4: Installing
30" and 36" Dual Fuel Ranges (Figures 6 and 7)
Thermador Service Part No. | Qty | Description |
415078 | 4 | Screw, Phillips, #10 x |
600413 | 1 |
IMPORTANT INSTALLATION INFORMATION:
•The
•The thickness of the wall or floor may require use of longer screws, available at your local hardware store.
•In all cases, at least two (2) of the bracket mount- ing screws must be fastened to solid wood or metal.
•Use appropriate anchors when fastening the mounting bracket to any material other than hard- wood or metal.
•Prepare holes at fastener locations as identified below:
FIG. 6 - Mounting |
-For walls, wall studs, or floors composed of solid wood or metal, drill 1/8" pilot holes.
-For walls or floors composed of drywall, sheet- rock or other soft materials, drill 3/16" holes to a minimum depth of
-For walls or floors composed of concrete or concrete block, drill 3/16" holes to a minimum depth of
-For walls or floors having ceramic tile cover- ing, drill 3/16" holes through the tile only, then drill into the material behind the tile as indi- cated immediately above.
•If the range is moved to a new location, the
MOUNTING ANTI-TIP BRACKET
The alternative floor mounted bracket shall be installed as follows:
a)Place bracket on floor in position shown in Figure 7 (Bracket may be used in either corner of the installation area).
b)Secure to floor or wall stud.
c)Later, when the unit is installed, the adjustable leg will slide under the bracket.
FIG. 7
➤
➤
from edge of range
➤
either side)
11