•Putting out grease fires by closing the lid is not possible. Grills are well ventilated for safety reasons.
•Do not use water on a grease fire. Personal injury may result. If a grease fire develops turn knobs and LP tank off.
•Do not leave grill unattended while preheating or burning off food residue on high. If grill has not been regularly cleaned a grease fire can occur that may damage the product.
Before Your First Cookout
•Light burners, check to make sure they are lit, close the lid and warm up grill on HIGH for 15 minutes. Curing of paint and parts will produce an odor only on first lighting.
Ignitor Lighting Traditional and Quick Set
▲Do not lean over grill while lighting.
1.Open lid. Turn on gas at LP tank.
2.Turn LEFT knob to 
IGNITE.
3.Push IGNITOR Button 
rapidly, or 
hold, turn Ignitor Knob 
(up to 5 times) to light. Be sure burner lights and stays lit.
4.If burner does not light turn knob(s) to OFF, wait 5 minutes, try again.
5.Turn RIGHT knobs (if featured) to 
IGNITE to light other burner(s).
6.If IGNITOR does not work, follow match lighting instructions.
After Lighting: Turn knob(s) to HIGH position for
Match Lighting Traditional and Quick Set
▲ Do not lean over grill while lighting. 1. Open lid. Turn on gas at LP tank.
2. Place lit match into match lighting hole from outside grill bottom (as shown).
3. Push in and turn Single or RIGHT knob to 
IGNITE. Be sure burner lights and stays lit. 4. Light left burner (if featured) by pushing LEFT knob
in and turning to 
IGNITE.
After Lighting: Turn Knob(s) to HIGH for
Match lighting hole is in bottom or side
11
