TOA Electronics H-1 Mounting the Speaker Directly to an Electrical Box, Removing the Trim Piece

6.3. Mounting the Speaker Directly to an Electrical Box

The H1 speaker system can also be mounted directly to an electrical box*. Follow Steps 2 and 3 for

instructions. In this case, use the outward-facing holes in the mounting bracket when mounting to the wall or

ceiling.

*Distance between mounting holes (A) x (B): 254 mm (10") x 66.7 mm (2 5/8") or

255.6mm (10 1/10") x 55.6 mm (2 3/16")

Electrical box

Memo

Electrical box mounting screws are attached to the H-1 speaker.

H-1 speaker

Note: The distance between the wall or ceiling surface and the box bottom surface must be 45 mm or more.

When using the Raco 953 electrical box, be careful in installation because it is shallow.

6.4. Removing the Trim Piece

When removing the Trim Piece for maintenance or repair, squeeze its sides by hand to create a gap between the

Trim Piece and wall/ceiling, then insert a screwdriver blade into the gap and pry off the piece.

Caution

If you raise either right or left side of the Trim Piece by force, it may be broken. Pull the both sides out evenly and

gradually.

9