TOA Electronics H-1 specifications Wiring and impedance changes

1-4. Clamp the wall or ceiling panel using the two board clamps, and secure with the clamp screws.

Step 2. Wiring and impedance changes

2-1. Pull the cables out of the mounting hole in the wall or ceiling, then strip the insulation back about 5mm from the cable ends.

Note

Usable cable: Solid cable or stranded cable (0.2 mm2

-2.5 mm2) (Corresponding to AWG No.

24-14)

About 5 mm

2-2. Remove the detachable input connector from the speaker, then loosen the connector screws with a small slot screwdriver.

2-3. Insert the stripped cable ends into the input
connector, and tighten the connector screws.	• When not bridging	• When bridging
	connections	connections

Note	From amplifier
When not bridging connections, be sure to also
tighten the screws of the terminals not in use to avoid
vibration or rattling noise.

To next

speaker

6