TOA Electronics H-1 specifications the angle, retighten the screws, Adapter Panel, Memo

3-2. Loosen the angle adjustment screws. After adjusting

the angle, retighten the screws.

Tip

The mounting angle can be adjusted for up to ± 45 °. Since the mounting bracket is marked with mounting

angles at 15 ° intervals, use this marking as a guide when adjusting the angle.

Stud screw

Angle adjustment screw

3-3. Align the two securing clips on the Trim Piece with

the speaker's two stud screws, then push the Trim Piece onto the speaker until the Trim Piece is snug to

the wall or ceiling surface.

Securing clip

Trim Piece

6.2. Mounting the Speaker to an Electrical Box Using The Adapter Panel

H-1 speaker

Stud screw

The H-1 speaker system can be mounted to walls or ceilings using an electrical box*. Mount the Adapter Panel to the electrical box as shown below. Further mounting procedures are the same as detailed in Steps 2

and 3.

Distance between mounting holes (A) x (B): 254 mm (10") x 66.7 mm (2 5/8") or

255.6 mm (10 1/10") x 55.6 mm (2 3/16")

Electrical box

Adapter Panel

H-1 speaker

Memo

Electrical box mounting screws are attached to the H-1 speaker.

8