HANDL. B2450_scan.qxd
Butler 2450
4.23 Changing the PIN code
Certain functions are only available if you know the PIN code of the telephone.
The PIN code has 4 digits. The default PIN code setting is ‘0000’. If you would like to change the default PIN code and set your own secret code, do the following:
•Press the Programming key 
.
•Press the Up or Down key 
repeatedly until ‘SETTING’ appears on the display.
•Press the Programming key 
.
•Press the Up or Down key 
repeatedly until ‘PIN CODE’ appears on the display.
•Press the Programming key 
.
•‘OLD CODE’ appears on the display.
•Enter the old PIN code. Use the number keys.
•Press the Programming key 
.
•‘NEW CODE’ appears on the display.
•Enter the new PIN code in. Use the number keys.
•Press the Programming key 
.
•‘AGAIN’ appears on the display.
•Enter the new PIN code again. Use the number keys.
•Press the Programming key 
.
•You hear a confirmation tone. The new PIN code has been set.
Caution : Do not forget your personal PIN code. If you do, you have to restore the default settings
(reset – see section 4.31).
4.24Subscribing a handset to a Butler 1000, 1010, 1210, 2405, 2410, 2450 base
unit
In order to be able to make and receive telephone calls, a new handset has to be subscribed to the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is sub- scribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Butler 1000, 1010, 1210, 2405, 2410, 2450 handset and base unit!!
Keep the Paging key 
on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator 
will blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset:
• Press the Programming key 
.
• Press the Up or Down key 
repeatedly until ‘BASE SUB’ appears on the display.
• Press the Programming key 
.
• ‘BASE _‘ appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to
Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit number. It is best to use ‘1’ .
ENGLISH
147
