148
Butler 2450
148
•‘SEARCHING’ and the symbol appears on the display.
•The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds when the handset has found the base unit.
•Press the Programming key .
•‘PIN’ appears on the display.
•Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the number
keypad.
•Press the Programming key .
•The handset is subscribed to the base unit.
4.25 Subscribing Butler 2450 handset on another base (other brand/model)
Put the base in subscription mode (see manual of the base). If the base is in subscribing mode,
you have to do the following to subscribe the handset:
•Press the Programming key .
•Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.
•Press the Programming key .
•‘BASE _‘ appears on the display.
•Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
•‘SEARCHING’ and the symbol appear on the display.
•The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds once the base unit is found by the handset.
•Press the Programming key .
•‘PIN’ appears on the display.
•Enter the 4-digit PIN code of the base unit. Use the number keypad.
•Press the Programming key .
•The handset is subscribed to the base unit.
4.26 Subscribing a Butler 1800T handset to a Butler 24xx base unit
The below procedure only applies to a Butler 1800T handset and Butler 24xx base unit!!
Press the Paging key on the base unit for 10 seconds until the Line/Charge indicator
op the base unit starts to blink quickly. The Line/Charge indicator will blink quickly for one
minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
•Press the key once.
•Press the OK key and select a base unit (1-4) with the keys.
•Press the OK key.
•Enter the PIN code of your base unit. Usually: 0000.
•Press OK. The Butler 1800T now searches for your DECT base unit. As soon as it finds it, you
will see the identification code of this base unit on the display.
•Press OK to confirm your selection or press ESC to cancel the subscription.
4.27 Removing subscription of a handset to a base unit
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
HANDL. B2450_scan.qxd 03-09-2002 17:05 Page 148