Topcom Babytalker 2500
4.5Link
Do not place the baby unit or cables in the crib or within the arm reach of the baby (at least 1 meter away).
When using the Babytalker the first time, it is adviced to test the connection.
•Install the parent unit in the same room as the baby unit, but have at least 1 meter between the 2 units.
•When both units are switched on, the parent unit will search for the baby unit.
•The green link LED (9) on the parent unit will flash until they communicate. Once the link is established, the LED will light continuously.
•The voice captured by the microphone will be audible on the parent unit.
•The level of the detected speech is represented by the LED’s on top of the parent unit (1).
•When the speech reached the maximum level, a beep will be audible.
•When the connection is established, move the parent unit to the monitor room, but within the operation range.
•When there is no connection, an alert signal (double beep) will be audible (out of range warning) and the green connection LED will blink.
•Move the parent unit closer until the link is
4.6Paging
When your parent unit is lost, you can track it by pressing 
(18) on the baby unit for 2 seconds.
The parent unit will emit a high beep tone for 30 seconds which helps you to find it very easily.
•Press 
on the parent unit (2) briefly to stop the beep.
5Using the Babytalker 2500
5.1Volume adjustment
5.1.1 Parent unit
There are 5 volume levels on the parent unit.
•Press 
(11) to increase the volume level.
•Press 
(10) to decrease the volume level.
•When ‘OFF’ is displayed, the babies crying will only be visible by the LED’s on top of the unit.
5.1.2 Baby unit
•Press 
(24) to increase the volume level.
•Press 
(23) to decrease the volume level.
The volume of the babyunit has effect on the talk to baby mode and when the melody is playing.
6 | Topcom Babytalker 2500 |
