12 Setup
In this case, you will need to connect a ca-
blefrom the RF OUTsocket to the antenna
connectoron your television. Toensure your
televisioncan also pick up existing analogue
channelsas well, you will need to connect a
cablefrom your television antenna to the RF
INconnector.
Tune your television set to channel 36 (or
rarely43) so that you can see the output from
thedigital receiver.

2.4.3 Connectingto your video cassette recorder

Thedigital receiver can also output video to another appliance
suchas a video cassette recorder or video receiver through an
auxiliarySCART connector.
Youwill need to obtain a SCART cable to use
theauxiliary SCART connector. Plug one end
ofthe cable into the VCR socket on the digital
receiver,and the other end into the match-
ingsocket on your video cassette recorder or
suchlike.
2.5 Switching on for the first time
Nowthat you have your digital receiver connected, you should
plugit in to a mains socket. Ensurethat your television set is
turnedon, so that you will be able to see the display from the
digitalreceiver.

2.5.1 Insertingbatteries in the remote control

Toinsert the batteries, open the battery compartment by remov-
ingthe lid, and then insert the batteries observing the polarity,
whichis marked on the base of the battery compartment.