4.1 Searching broadcasting services 27
When you switch to an service, if the service is provided by a satellite other than current one, it will take longer time than usual because the antenna has to turn to its position.
To use the DiSEqC 1.2 protocol, select the Installation > Motor- ized DiSEqC 1.2 menu. You should see a screen like the left figure.
At first you have to set the Mo- torized DiSEqC 1.2 option to En- able.
To get the correct position of your desired satellite, perform the following steps:
1.Choose your desired satellite at the Satellite Name op- tion.
2.Set the DiSEqC Command Mode option to User.
3.Set the Motor Control option to Goto. Then the antenna will turn toward your selected satellite by the position data that the digital receiver has.
4.If the receiving quality, which is displayed at the bottom right of the screen, is not good, tune the antenna finely with the Movement option. If you set it to 2(E), the an- tenna will move to the east by two degrees. At this time you had better check the receiving quality of every trans- ponder and choose the best one at the Transponder (or Frequency) option. It will be helpful to your fine tuning.
