Toro 212 manual Resetting The Controller Memory, To Reset The Permanent Program Figure

Resetting The Controller Memory

The GreenKeeper 212 program memory can be reset to the permanent program values or cleared completely at any time without removing power.

Resetting the permanent program erases all user input and replaces it with the permanent program values.

Clearing the program memory sets all program values to Off (i.e., no active days, program start times or station run times). You may find that this simplifies programming the controller if your watering requirements are quite different than the permanent values.

Note: When power is first applied, the GreenKeeper 212 will always reset to the permanent program values.

To Reset The Permanent Program (Figure 4)

Turn the control dial to the OFF position. OFF will be displayed.

Press the +/ON and –/OFFbuttons at the same time until CLR is displayed.

Return the control dial to the RUN position.

To Clear The Memory (Figure 5)

Turn the control dial to the OFF position. OFF will be displayed.

Press the +/ON and NEXT buttons at the same time until CLR 0 is displayed.

Return the control dial to the RUN position.

Figure 4

2

3

1

2

Figure 5

2

3

2

1

15