Washer | Toro TWRS guide

A pipe-mount adapter is provided to enable sensor installation on a secured section of 1/2" (13mm) diameter Schedule 40 PVC pipe.

Note: Metal pipe or conduit may interfere with radio signal transmission and is not recommended.

Remove and replace the Quick Clip bracket with the pipe-mount adapter. Ensure the friction washer is installed between the adapter and housing tabs as shown in Figure 14.

Figure 14

Washer

12

Check the sensor for vertical alignment. To adjust, loosen the Phillips screw slightly, align as needed and tighten screw. See Figure 15.

Figure 15

Image 14

Toro TWRS manual Washer

Contents

User’s Guide Contents Page Getting Started Here’s all there is to it Step Receiver Module Features Installing the Receiver Module Connecting the Receiver Wires Wiring Procedure I sensor-ready Wiring Procedure II no sensor feature Normally-open Sensor Initial System Test Least of 15 seconds to establish communication Sensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Scale Set Temperature Activation Threshold Twrfs models onlySelect Temperature Threshold Page Smart Bypass Feature Water Delay Feature Refer to Sensor Module Battery Replacement on Signal Strength DisplayBattery Strength Display Dry Out Feature Fail Safe Feature Prolonged Active Mode Loss of communication Set or Restore the Sensor Address Code Turn the Receiver Module Off and On Sensor Module Battery Replacement Unscrew and remove the bottom cap from the sensor housing To improve signal strength TroubleshootingSolving Reception Problems Receiver display is blank Sensor module does not activate the receiver at close range Specifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS