Step | Toro TWRS manual

Step 3

Step 4

A sensor installation site is chosen and the system is tested again to verify operation.

The sensor is adjusted to the preferred rainfall activation level.

Step 5

Step 6

The sensor is installed using the Quick ClipTM mounting bracket or pipe-mount adapter.

The operating features are set to your preferences.

3

Image 5

Toro TWRS manual Step

Contents

User’s Guide Contents Page Here’s all there is to it Getting Started Step Receiver Module Features Installing the Receiver Module Wiring Procedure I sensor-ready Connecting the Receiver Wires Normally-open Sensor Wiring Procedure II no sensor feature Least of 15 seconds to establish communication Initial System Test Sensor Module Features Installing the Sensor Module 1/4 Washer Freeze Sensor Site Selection Select Temperature Scale Set Temperature Activation Threshold Twrfs models onlySelect Temperature Threshold Page Water Delay Feature Smart Bypass Feature Refer to Sensor Module Battery Replacement on Signal Strength DisplayBattery Strength Display Fail Safe Feature Dry Out Feature Loss of communication Prolonged Active Mode Turn the Receiver Module Off and On Set or Restore the Sensor Address Code Unscrew and remove the bottom cap from the sensor housing Sensor Module Battery Replacement To improve signal strength TroubleshootingSolving Reception Problems Sensor module does not activate the receiver at close range Receiver display is blank Specifications Toro Promise Five-year Limited Warranty FCC ID OF7TWRS