Toro TWRS manual Turn the Receiver Module Off and On, Set or Restore the Sensor Address Code

Turn the Receiver Module Off and On

1.To turn the receiver module Off, press and hold the Adjust button until two dashes are displayed (approximately 5 seconds), then release.

2.To turn the receiver On, press the Setup button two times. The receiver will return to the normal display mode within approximately 10 seconds.

Set or Restore the Sensor Address Code

Figure 28

The receiver and sensor modules are factory-matched to communicate using a specific address code. If you have purchased a new sensor module or it becomes necessary to reset the address code, use the following procedure to reestablish communications:

1.Press and hold the Smart Bypass button until all three Water

Conservation indicators are illuminated and the display prompt begins blinking (approximately 15 seconds). See Figure 29.

2.Activate the sensor module at close range by pressing the test spindle until the Sensor Status indicator is illuminated, then release the test spindle. Refer to step 3 of “Initial System Test” on page 8 for additional information.

Figure 29

Note: If the Water Conservation level is set to Medium or Maximum ,or the Dry Out feature is in use, the sensor system will be activated. Press the Smart Bypass button to reset the receiver to the Monitor mode.

20