34
This section provides several
quick start programming steps
to prepare your new facsimile
for immediate use.
These procedures are a simple
version of the detailed proce-
dures listed in the manual.
Next to each procedure head-
ing is a convenient page num-
ber reference for the detailed
procedure. Should you have
any difficulty with these simple
procedures, refer to the pages
listed for more information.
It is highly recommended that
you take the time to read
through this manual to get the
most from your new TOSHIBA
facsimile.
- QUICK START
Press:
MENU
, ,
Enter your user ID (company
name) using the Dial Keypad,
press:
If you communicate internation-
ally, select:
Otherwise, select:
Enter your facsimile’s tele-
phone number, press:
Displayed for 2 seconds
Press:
STOP

Terminal ID

Setting the Terminal ID (Page 42)
1
Your TOSHIBA facsimile has
been preset from the factory to
receive facsimile messages.
No special setup is required to
receive facsimile messages.
Load your document face down
into the Document Support.
Dial the remote facsimile using
the Dial Keypad located on the
Operation Panel. Remember to
include any access numbers
such as 9 or press the
REDIAL
PAUSE
af-
ter the access number if you
normally have to wait for a dial
tone.
After the remote facsimile
number has been entered into
the keypad, press the green
START key.
START

Transmitting Receiving

Sending a Facsimile
(Page 93)
2
Receiving a
Facsimile (Page 102)
3
NAME (40MAX)
[ ]
2.NO
INT. CODE ?
1.YES
FAX NUMBER (20MAX)
[ ]
COMPLETED
INITIAL SETUP
3.TERMINAL ID
JAN-31 09:43 AM 100%
AUTO RECEIVE