15
G8000 Series Installation and Operation Manual
6.1 Warning Label Locations
FIGURE 6.2 – 80/100/125 KVA UPS WARNING LABELS
DANGER
Hazardous voltages are used in the operation
of this equipment and could cause severe personal
injury or loss of life.
The following precautions should be observed to
reduce the risk of injury or death.
HAZARDOUS VOLTAGES
Only qualified technicians familiar with this equipment and the
information supplied with it should be permitted to install and
operate this equipment.
Installation of electrical equipment must be done in
accordance with National Electrical Code and any other state
or local codes. Proper grounding and conductor sizing must
be installed for safe operation.
During operation, keep all covers in place and cabinet
doors shut.
When performing visual inspections and maintenance, if
possible, be sure the UPS is turned off and the incoming
AC feed is turned off and locked out.
If it is ne cessary to make measurements with the power
on, do not touch any electrical connection points. R em ove
all jewelry from wrists and fingers. Make sure test equipment
is in good, safe operating condition.
While servicing, stand on some type of insulation, and be
sure not to be grounded.
Follow the safety instructions given in the equipment manual
carefully and observe all danger, warning and caution notices.
40308
The UPS and Battery Cabinet will have hazardous
voltages present even after the AC feed is turned off.
DANGER
AC VOLTAGE
This UPS receives power from more
than one source. Disconnect all AC
sources before performing any service
or testing inside this unit
48082
2
V
3
W
4
U
REFER TO INSTRUCTION MANUAL FOR WIRE SIZE AND TIGHTENING TORQUE
480 V
AC INPUT
480 V
BYPASS INPUT
1
U
480V
AC OUTPUT
400 V
BATTER Y
5
V
6
W
7
N
8
U
9
V
10
W
11
N
USE COPPER CONDUCTORS ONLY!
12 13
-
+
(B) 40308(A) 48082
(C) 56875 FOR 100, 150, 225KVA
(C) 58708 FOR 300KVA
2
V
3
W
6
U
REFER TO INSTRUCTION MANUAL FOR WIRE SIZE AND TIGHTENING TORQUE
480 V
AC INPUT
480 V
BYPASS INPUT
1
U
480 V
AC OUTPUT
400 V
BATTER Y
7
V
8
W
9
N
10
U
11
V
12
W
USE COPPER CONDUCTORS ONLY !
45
-
+
58708
PN 40830
Incorrect fuse replacement size
may r esult in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
CRITICAL FUSE SIZING
WARNING
(D) 40830
(E) 39561
DANGER
Turn off and lock ou t all power sources.
Wait at least five (5) minutes for power
to dissipate then check voltage before
servicing.
Capacitors stay c harged after power
has been s hut off.
Accidental contact with live parts can
cause personal injury and death.
RISK OF ELECTRIC SHOCK
39 56 1
(F) 58705 SERIAL LABEL
®
LI STED
27E5
MFD. I N U.S .A. FR OM FO REIGN AND DO MES TIC C OMP ON EN TS
HOUSTON, TEXAS
587 05
®
UNINTERRUPTIBLE POWER SUPPLY
(G) 57055
GND
(I) 40831
Risk of electrical shock.
PN 40831
Heat sink not grounded.
CAUTION
Disconnect UPS and electrically
test heat sink before touching.
(J) 57053