60 Getting Started
Adding memory
5.375 x 8.375 ver 2.3
Removing a memory module
If you need to remove a memory module:
1Complete steps 1–8 in “Installing a memory module” on
page 55 to shut down the computer and open the memory
module slot cover.
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the device.
Do not remove the memory module while the computer
is in Standby or Hibernation mode. The computer could
hang up the next time you turn it on and data in memory
will be lost. In either of the above cases, the Standby
configuration will not be saved.
The following message appears when you turn on the
power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
2Pull the clips away from the memory module.
The memory module pops partially out of the slot.
3Carefully remove the memory module from the slot.