AR-B1375/AR-B1376 User s Guide
6-6
6.4 ROM DISK INSTALLATIONThe section describes the various type SSDs’ installation steps as follows. The jumper and switch adjust as SSD’s
different type to set.
(1) Switch and Jumper Setting
Step 1: Use jumper block to set the memory type as ROM (FLASH).
Step 2: Select the proper I/O base port, firmware address, disk drive number and EPROM type on SW1.
Step 3: Insert programmed EPROM(s) or FLASH(s) chips into sockets starting at MEM1.
ON
123456
OFF
Figure 6-4 UV EPROM (27CXXX) Switch Setting
EPROM (128KX8, 256KX8, 512KX
8
2
1
3
ABC
1MX8 EPROM (Only)
2
1
3
ABC
123
M1~M3
JP4
123
JP4
M1~M3
Figure 6-5 UV EPROM Jumper Setting