MAINTENANCE
Lint collector
Clean the lint collector after every use.
1Remove the lint collector by lifting it up. When the machine has stopped in a place in which it is difficult to lift the lint collector out, turn the basket by hand to a more convenient place and remove the lint collector.
2Remove the lint by turning the lint collector inside out.
3Replace the lint collector.
• In the event that the net is damaged,consult your nearest dealer.
Softener case
Remove and clean after every ten usages. | Installation | Catch | ||
Removal | 1 | Fit in the bottom. |
| |
1 | Hold down the each. | 2 | Then press in the top until the |
|
2 | And pull toward you. |
| catch catches. |
|
Caution |
|
|
| |
• | Water in the case may freeze in cold weather. |
|
| Softener case |
If this occurs, remove the case, immerse in warm water (less than 40°C) for 10 minutes, and replace after dried well.
Washing machine body and panel
Before performing any maintenance on your washing machine, be sure to remove the electrical plug from its power source. The main body and control panel may be cleaned by wiping with a soft cloth soaked in water.
Caution: Never clean the body or control panel with benzine, thinner, cleanser, or other chemical cleaners. Use of such chemicals can discolor or damage parts.
Cleaning the tub
"TUB CLEANING" course
The dirt from clothes or wastewater on the wash/spin basket will cause the smell or the problem of water draining. Such dirt from the washing process will then make the laundry dirty. If you are in such case, please use "Tub Cleaning" program once a month. Or in case the clothes have been starched, please use the "Tub Cleaning" program to remove the dirt of the starch from the basket.
•Normally use detergent.
•The amount of detergent must be more than the guided Standard Detergent Amount.
•Do not use "Tub Cleaning" program continuously.
•If there is a great amount of dirt inside the basket, you had better use the
Please follow the instruction labeled on the cleaner bag.
L "Tub Cleaning" Process
Water Intake and stir | about 5 min |
Soaking | about 20 min |
Washing (Tub cleaning) | about 3 min |
Draining water and spin | about 4 min |
Water Intake and stir | about 5 min |
Rinsing | about 3 min |
Draining water and spin | about 1 min |
1Turn the POWER on.
2Press the COURSE button and select
TUB CLEANING.
3Press the START button.
•During the "Tub Cleaning" program, only the TUB CLEANING indicator will light on.
4When the pulsator (spinning board) starts to spin, add the
•Do not put any clothes in the basket during the "Tub Cleaning" program.
5Close the lid.
•If the lid is opened during the operation, the operation will stop before the draining and rinsing process.
Finish "Tub Cleaning" process.
•Beeping when the operation is finished.
10
6348100701 | 10 | 22/10/08, 11:18 |
