INSTALLATION

Choosing an installation location

It is dangerous to place the washing machine in an unstable location, since it may move during vibration.

It will increase the sound produced by the machine when it vibrates during use.Install your washing machine in a level, stable place.

When you move washing machine, hold the handles on the sides.

There are moving parts, electrical parts and steel plates

Never touch on the cabinet bottom by hands. Never lift at the cabinet bottom by hands.which may cause electrical shock or injury.

When the machine is covered.

Do not use the cover made of chloric vinyl. Sometimes it damages resinous parts and painted surface. When you use the cover made of chloric vinyl, put the cloth between the machine and the cover.

Avoid place where the machine is exposed to direct sun-

light.

Plastic parts may become deformed or discolored.

Avoid places where the machine may become frozen during cold weather.

Allow a space of at least 5 cm from the sides and rear of

When placed too near to walls or other objects, the

vibration of the machine during operation may cause them to shake.the machine to the nearest vertical object.

Allow 5 cm

Installing the bottom cover

Put the bottom cover into the bottom of the washing machine, and fix the bottom cover with screws.

1 Lay down the washing machine

2 Align the bottom cover with

3 Fasten the screws on 6 positions.

on a flat object such as a corrugated board

the taps of the hooks of the

 

so that the front side is down.

bottom cover left & right. (4 taps)

 

F R ONT

 

 

F R ONT

BOTTOM C OVE R (LE FT)

BOTTOM C OVE R (R IG HT) S UP P OR T P LATE

Installation

Adjust the legs so that the body of your washing machine is level. (The two legs are adjustable.)

After loosening the adjusting

1 nut, adjust the leg to the proper height by turning it. Then tighten the adjusting nut se- curely once again.

Leg nut

When the leg height is difficult to

A weight attached to a string may be used

2 adjust because of floor slope or

3 to check to ensure that your washing

unevenness, place a board of

machine is level.The distance is less than

sufficient thickness to prevent

1 cm between A and B

breakage under the affected legs

 

to allow adjustment to a level po-

 

sition.

 

Loosen

Tighten

String

 

Leg

RaiseLower

Check the distance

11

6348100701 (11-15)

11

22/10/08, 11:19

Page 11
Image 11
Toshiba AW-7480EM owner manual Installation, Choosing an installation location, Installing the bottom cover