DESCRIPTION AND OPERATION OF PANEL PARTS
CHILD PROOF MODE DISPLAY
•Check this to see if the CHILD PROOF mode is ON (lit) or warning (flashing).
“PRESET” button
•You can set/reset the CHILD PROOF mode.
•You can set the time until washing finished.
“SUPER SPIN DRY” button
PROCESS DISPLAY
•Operating process is indicated by flashing. Remaining process is indicated by lightening.
“COURSE” button
•You can select the program suitable for the laundry.
“SELECT” button
•Select either the WASH, RINSE, or SPIN cycle as you desire.
“START/HOLD” button
•Press this pad when you want to start.
•Press this pad when you want to hold.
“POWER” button
•Press this button to power off/on.
•Power is automatically turned off about 15 seconds after the end of operation, or about 10 minutes later if the operation is not on.
WATER LEVEL
|
• The water level is set linearly by adjusting to |
the washing volume. If the water level is |
assigned at the point with no particular |
indication, then the nearest level lights up. |
• In this |
DETERGENT GUIDE
•The amount of supply using the measure spoon accompanying the compact detergent is displayed.
One spoonful of detergent denotes about 55L of water consumption
Depending on the kind of detergents, amount of water consumption by one spoonful changes. Adjust the detergent volume according to the particular detergent in use.
illuminates when water supply finishes. | ||
• By pressing the "START/HOLD" button while | ||
water is in the wash basket, the highest | ||
water level lights up. | ||
| Button Setting | |
• By pressing the | button, a desired | |
water level can be obtained. | ||
• Illumination shifts to the direction where the | ||
higher water level is indicated as the result of | ||
pushing the | button. | |
• While using the "tub cleaning" program, the | ||
water level will be automatically at High and | ||
the | button cannot be used. | |
RESUME FUNCTION (POWER FAILURE RECOVERY)
2 1
If a power failure occurs during operation, the washer memorizes the remaining process. After the electricity recovers, you can resume it.
1Turn the POWER on.
The progress and course indicators of the remaining process will be flashing, and the buzzer sounds for 5 seconds.
2Press the 
button.
NOTE • For “PRESET MODE” , if the power failure occurs before the machine starts operating, the machine will cancel the preset time. Therefore, you have to reset the time.
• Press the 
button to clear the remaining process.
4
6348100701 | 4 | 22/10/08, 11:13 |
