Toshiba B-852-TS12-QP owner manual Assembling the Accessories, Assembling the Supply Holder Frame

2. PRINTER SETUP

ENGLISH VERSION EO1-33028

2.3 Assembling the Accessories

2.3Assembling the Accessories

2.3.1Assembling the Supply Holder Frame

NOTE:

Make sure that the two small flanges at each end of the Supply Holder Base fit into the small rectangular holes at the bottom of the Supply Holder Frames before tightening the Wing Bolts.

The following procedure outlines the steps required to assemble the Supply Holder Frame and attach the frame to the B-852 printer in preparation for loading the media.

1.Assemble the Supply Holder Frame (L) and Supply Holder Frame (R) to the Supply Holder Base using the two M-4X6 Wing Bolts supplied, as shown below.

Supply Holder Frame (L)

Supply Holder Frame (R)

Wing Bolt

Supply Holder Base

Wing Bolt

NOTE:

After attaching the supply holder frame to the printer, make sure that it is assembled firmly.

2.Attach the assembled Supply Holder Frame to the rear of the B-852 printer by inserting the hooks of the Frame into the two slots in the rear of the printer as shown in the figure below.

Hook

E2- 3