Toshiba B-852-TS12-QP A1.3.3 Detection Area of the Reflective Sensor, A1.3.4 Effective Print Area

APPENDIX 1 SPECIFICATIONS

ENGLISH VERSION EO1-33028

A1.3 Media

A1.3.3 Detection Area of the Reflective Sensor

The reflective sensor is movable from the center to the left edge of media.

The reflection factor of the black mark must be 10% or lower with a waveform length of 950 nm. The reflective sensor should be aligned with the center of the black mark.

Sensor should be positioned at the center of the black mark.

Min. 2.0 mm

Min. 10 mm

Center of media

Detecting the black marks on the back.

Media feed direction

Sensor is movable within this range.

A1.3.4 Effective Print Area

The figure below illustrates the relation between the head effective print width and media width.

Out of print range Out of print range

216.8 mm±0.2

12.6mm (Head Effective Print Range) 12.6mm

242 mm (Max. media width)

The figure below shows the effective print area on the media.

Area to be detected.

1mm

Start line
				Media height
1 mm from the				10 – 640 mm
					1 mm from the right
left edge of		Guaranteed print area
media					edge of media
						Media feed direction
		1mm
				Area to be detected.
			Media width
	(backing paper width is not included.)

NOTES:

1.Be sure not to print on the 1-mm wide area from the media edges (shaded area in the above figure).

2.The center of media is positioned at the center of the print heads.

EA1- 4