Toshiba D-VR17KB owner manual Setting the Clock, Move, Auto Clock Setting, 24 EN

E9GA0BD_EN.book Page 24 Monday, March 26, 2007 10:14 AM

Move

You can replace two channels.

1 In stop mode, press [SETUP]. Select “General Setting” using [U / D], then press [ENTER].

2 Select “Channel” using [U / D], then press [ENTER].

3 Select “Move” using [U / D], then press [ENTER].

4 Select the position number of which you want to change the channel using [U / D], then press [ENTER].

You cannot select a position number where “– – –” appears next to the number, because “Skip” is set to “ON” for that position number.

5 Move the channel to another position number using [U / D], then press [ENTER].

• To move another channel, repeat steps 4 to 5.

6 Press [SETUP] to exit.

Setting the Clock

Auto Clock Setting

Channel Tuning must be set before setting Auto Clock.

1 In stop mode, press [SETUP]. Select “General Setting” using [U / D], then press [ENTER].

2 Select “Clock” using [U / D], then press [ENTER].

General Setting

Playback

Display

Video

Recording

Clock

Channel

DivX

Reset All

3 Select “Auto Clock Setting” using [U / D], then press [ENTER].

4 Select “ON” using [U / D], then press [ENTER].

The current time will be set automatically.

5	Press [SETUP] to exit.
6	Press [	ON / STANDBY] to turn
	off.

The Auto clock function is activated.

This unit will search for the time every time when the power is turned off. Leave the unit off for several minutes to give it time to set the clock.

Hint

• If you want to cancel “Auto Clock Setting,” select

“OFF” using [U / D], and then press [ENTER] at

step 4.

Note

• The default setting of “Auto Clock Setting” is “ON.”

• The clock may set itself automatically after you

connect the antenna cable to the unit and plug in the

mains cable. In this case, the current time will

appear on the front panel display.

• To set the clock automatically, the channel assigned

to “P04” must receive the PDC signal.

• The clock cannot be set automatically if you are not

receiving a channel in your area that carries a time

signal. In this case, set the clock manually.

• Once the auto clock setting is performed, the unit

will correct the current time by receiving PDC

broadcasts whenever the power is turned off.

• The unit will correct the current time automatically at

8:00, if the unit is in standby mode.

• Between 23:00 and 1:00, the Auto Clock function

will not operate even when the power is turned off.

24 EN