Windows Setup Guide for | 23 |
Reboot the machine. Select [Control Panel] – [Touch Panel] to display the “Touch Panel Property” screen. On this screen, select [Calibration] – [Execute] to set up calibration.
IMPORTANT:
*Unless any of the PS/2 mouse, the serial mouse or the USB mouse has been connected, the touch panel driver cannot be loaded properly, disabling the calibration setup. Connect any of the mice to let the machine recognize it.
4)Installing Other PCI Device Drivers
Designate the following folder to install the driver:
Video Controller: “Display¥SM712¥WinXP” in the driver kit
5)Changing the Serial Port Setting
On Windows XP, COM4 is recognized as if there are two. Therefore, either of them must be changed from COM4 to COM5 (SIO1).
IMPORTANT:
*No additional operation for the SIO1 port is required, since it cannot be actually used due to hardware configuration. However, since COM4 is recognized as if there are two, either of them must be changed from COM4 to COM5 (SIO1). The port addresses and IRQs for COM4 and COM5 should be set as be low:
•COM4
Port address:
IRQ:IRQ11
•COM5 (SIO1)
Port address:
IRQ:IRQ15
6)Updating the Driver
The driver kit contains divers newer than those supported by Windows. Update the drivers as required.
TOSHIBA TEC CORPORATION
