Manuals
/
Toshiba
/
Computer Equipment
/
Laptop
Toshiba
E2711 setup guide ST-6500 Setup Guide for Windows, Toshiba Tec Corporation
Models:
E2711
1
1
25
25
Download
25 pages
50.27 Kb
1
2
3
4
5
6
7
8
<
>
Setup on Windows NT
Setting up the Dual Display
Page 1
Image 1
ST-6500
Setup Guide for Windows
TOSHIBA TEC CORPORATION
Page 2
Page 1
Image 1
Page 2
Contents
TOSHIBA TEC CORPORATION
ST-6500 Setup Guide for Windows
1. Introduction
2. Setup on Windows 98/Windows 98SE
The following screen appears. Select “Reinstall Driver” to install the driver
4 Installing the SM712 Graphic Driver
6 Installing the PnP Touch Panel Driver
7 Changing the Serial Port Setting
8 Setting up the Dual Display
If the SM712 VGA board SMI has been inserted on the machine, when Windows 98 is installed, the on-board VGA Intel810E2 cannot be used after Windows 98 has been installed. On the “Device Manager” tab of the “System Properties” screen, the on-board VGA Intel810E2 is marked with “!”, which indicates the device is disabled. See the screen below
9 Cautions of dual-screen use by Windows98 and Windows98SE
Windows Setup Guide for ST-6500/ST-6500-C7
If “OK” button or “Cancel” button are clicked, error may occur
Apply button is clicked
TOSHIBA TEC CORPORATION
3. Setup on Windows NT
Even ID
5 Installing the SM712 Graphic Driver
7 Installing the PnP Touch Panel Driver
4. Setup on Windows
On the “Found New Hardware Wizard” screen, select “Search for suitable driver for my device” and click on Next
Page
COM4 Port address IRQIRQ11 COM5 SIO1 Port address 2E8-2EF IRQIRQ15
7 Setting up the Dual Display
On Windows 2000, the on-board VGA Intel810E2 is set as primary monitor. After Windows 2000 is installed, the on-board VGA is used for the screen display
5. Setup on Windows XP
On the “Found New Hardware Wizard” screen, select “Install from list or specific location” and click on Next
COM4 Port address IRQIRQ11 COM5 SIO1 Port address 2E8-2EF IRQIRQ15
TOSHIBA TEC CORPORATION
7 Setting up the Dual Display
