Toshiba EM1-33033E owner manual Built-in rewinder type

6. LOADING THE MEDIA

EM1-33033

6. LOADING THE MEDIA

Cutter type: Where a cutter is fitted load the media as standard and feed it through the cutter module.

NOTES: 1. Be sure to cut the backing paper of label. Cutting labels will cause the glue to stick to the cutter, which may affect the cutter quality and shorten the life.

2.If the top edge of label winds onto the platen in cut issue, set the DIP SW 1-5 to ON.

3.For the cutter type, the selection switch can be set to either position.

Media Outlet

Media

Cutter Module

Fig. 6-11

Built-in rewinder type:

1Remove two black screws and front plate.

2Fit the rewinder guide plate to the strip shaft, then attach it with the sems screws.

Tear-off Bar

Rewinder Guide Plate (FMBD0034501)

SM-4x6B Sems Screw

SM-4x6B Sems Screw

Adjustment Knob

SM-4x8 Sems Screw

Fig. 6-12

NOTES: Set the selection switch to the REWINDER position.

3Follow the procedure for strip type.

4 Adjustment

If the label skews when using built-in rewinder unit, turn the adjustment knob of the rewinder guide plate to correct the label feed. Clockwise turn moves the rewinder guide plate forward and counterclockwise moves it backward.

*When labels skew to the right:

Loosen the SM-4x8 sems screw with a philips-head screw driver. Turn the adjustment knob clockwise, and tighten the SM-4x8 screw when the rewinder guide plate is positioned correctly.

*When labels skew to the left:

Loosen the SM-4x8 screw with a phillips-head screw driver. Turn the adjustment knob counterclockwise, and tighten the SM-4x8 screw when the rewinder guide plate is posi- tioned correctly.

6-6