Toshiba EM1-33033E owner manual Ribbon, Media

2. SPECIFICATIONS

EM1-33033

2.3 Media

2.3	Media			Label				Tag paper
							Refer to the following
							NOTE 2. Black Mark		Black Mark
Stop		I					(on reverse side)	I	(on reverse side)
							Stop		Tag paper
position
							position
						E	Cut		F
	Cut
	position						position	Reference
				Reference
		J			1		A	coordinate 1	A
			H	coordinate		B		H
				Reference				Reference
				coordinate	2			coordinate	2
				G			Feed direction	G
				D
								C
				C
							Fig. 2-1
									[Unit : mm]

Item		Label dispensing mode		Batch mode		Strip mode		Cut mode
A	: Span of one label/tag			10.0 ~ 999.0	25.4		~ 999.0	Label: 38 ~ 999.0
								Tag: 25.4 ~ 999.0
B	: Label/tag length			8.0 ~ 997.0	23.4		~ 997.0	25.0	~ 993.0
C	: Width including backing paper				50.8		~ 112.0
D	: Label width				47.8		~ 109.0
E	: Gap length			2.0 ~ 20.0		2.0	~ 20.0	6.0	~ 20.0
F	: Black mark length (Tag paper)				2.0		~ 10.0
G	: Effective print width				10.0		~ 104.0
H	: Effectice	Label	Standard	6.0 ~ 384.0		21.4	~ 384.0	23.0	~ 384.0
	print length		Max. memory	6.0 ~ 896.0		21.4	~ 896.0	23.0	~ 896.0
		Tag	Standard	8.0 ~ 384.0		23.4	~ 384.0	23.4	~ 384.0
			Max. memory	8.0 ~ 896.0		23.4	~ 896.0	23.4	~ 896.0
I	: Print speed up/slow down area						1.0
J	: Black mark length (Label)				Refer to the following NOTE 2.
Maximum effective			Standard		192.0
length for on the fly issue			Max. memory		448.0
Outer roll diameter						ø200 Max.
Thickness			Label		0.13 ~ 0.17
			Tag		0.15 ~ 0.29

NOTES: 1. The media specification other than above are unchanged.

2.When marking black marks on label rolls, the following requirements must be satisfied. When the gap length is less than 4 mm:

The black mark length should be longer than the gap length. When the gap length is 4 mm or more:

The black mark should not overlap the gap for more than 4 mm and the following label.

2.4 Ribbon

Type	Spool type
Width	68 mm ~ 112 mm
Length	600 m
Outer diameter	ø90 mm (max.)

NOTES: 1. "On the fly issue" means that the printer can draw and print without stopping between labels.

2.To ensure print quality and print head life use only TOSHIBA TEC specified media and ribbons.

3.When using the cutter ensure that label length B plus inter label gap length E exceeds 35 mm. (i.e. label pitch should be greater that 35 mm.)

4.When rewinding the media onto the take-up spool in batch mode, the max. outer roll diameter should be 180 mm.

5.Use of rough media for the ribbon saving issue may cause ribbon smudges.

2-3