Toshiba EM1-33033E owner manual Put the media on the supply shaft

6. LOADING THE MEDIA

EM1-33033

6. LOADING THE MEDIA

4.Put the media on the supply shaft.

5.Pass the media around the damper, then pull the media towards the front of the printer.

6.Insert the ridge of the supply holder into the groove of the supply shaft until the media is fixed. Then turn the locking ring clockwise to secure the supply holder. This will centre the media automatically. NOTE: Do not over tighten the locking ring of the supply holder.

	Groove Ridge
Damper			Projection
		Supply Holder
	Media

Supply Shaft

Fig. 6-3

7.Insert the media into the paper holders of the media guide, adjust the media guides to the media width, and tighten the locking screw.

8.Check that the media path through the printer is straight. The media should be centered under the print head.

Media Guide

Media	Supply Holder
	Media Guide

	Paper Holder
Paper Holder	Print Head
Locking Screw	Media

Fig. 6-4

NOTE: When using the label rolled with labels facing outside, please remove the upper plates of both paper holders using the following procedure. Failure to do this may cause a paper jam error.

If you have any questions, please contact your nearest TOSHIBA TEC service representative.

6-2