Manuals / Toshiba / Computer Equipment / Printer

Toshiba B-870 SERIES, EM1-33039EE Threshold setting procedure For firmware version 1.3 or earlier

Models: B-870 SERIES EM1-33039E EM1-33039EE

1 34

Download 34 pages 52.87 Kb

Page 29

■Threshold setting procedure (For firmware version 1.3 or earlier)

11. GENERAL MAINTENANCE

EM1-33039E

11.5 THRESHOLD SETTING

■Threshold setting procedure (For firmware version 1.3 or earlier)

Turn the power on.

Load the Pre-printed label. (Any position)

Press the PAUSE key once.

Hold down the PAUSE key for more than 3 seconds and it will begin to feed. After it has fed 2 labels release or more the PAUSE key.

Press the RESTART key for ON LINE mode.

Threshold setting is now completed.

NOTES: 1. If the PAUSE key is not held down for more than 3 seconds in PAUSE mode the threshold will not be set.

2.If the PAUSE key is released before 2 labels have been issued the setting may not be correct and will have to be re-set.

11-7

Image 29

Toshiba B-870 SERIES, EM1-33039EE owner manual Threshold setting procedure For firmware version 1.3 or earlier

Contents

B-870 SERIES Table of ContentsOwner’s Manual TEC Thermal Printerfor USA only Safety Summary Safety SummaryMeanings of Each Symbol Safety Summary PrecautionsRequest Regarding Maintenance TABLE OF CONTENTS 1. INTRODUCTION 1.2 ACCESSORIES1.1 APPLICABLE MODEL B - 8 7 2 - Q Q2.1 PRINTER 2. SPECIFICATIONSAuto Ribbon Saving Mode 2.2 OPTION2. SPECIFICATIONS MEDIA2.4 RIBBON 3.1 FRONT/REAR VIEW 3. OVERVIEW3.2 OPERATION PANEL POWER LED GreenTurn the POWER OFF before 4. DIP SWITCH FUNCTIONSswitching 4. DIP SWITCH FUNCTIONS5.2 SETTING UP THE PRINTER 5. SET UP PROCEDURE5.1 REQUIREMENTS FOR OPERATION Interface Cables6.2 HOLDER STAND INSTALLATION 6. INSTALLATION PROCEDURE6.1 CONNECTING THE POWER CORD AND CABLES Head Lever Position 7. LOADING THE RIBBON8. Set the head lock plate 8. LOADING THE MEDIA 8. LOADING THE MEDIA5. Turn the Lock Levers of the Media Holders to the unlock position and readjust the Media position to the center. Then lock the Media Holders securely with the Lock Levers. Fit the Media Guides to the Media. Tighten the screw firmly An easy way to set the black mark sensor position Setting the feed gap sensor position8. The media is now loaded and the sensor position is set. Batch type Backing Paper Holder Media Backing Paper Backing Paper Release Bar3. Turn the power on Flash Memory Card 9. INSERTING THE OPTIONAL FLASH MEMORY CARD1. Turn the power off 10. CARE/HANDLING OF THE MEDIA AND RIBBON 10. CARE/HANDLING OF THE MEDIA AND RIBBON11.1 CLEANING 11. GENERAL MAINTENANCE7. Turn the pinch roller lever to the right 11.3 COVERS AND PANELS 11.2 UNDER THE MEDIA GUIDES11.4 REMOVING JAMMED MEDIA Cleaning the strip unit Cleaning the Cutter Unit11. GENERAL MAINTENANCE 11.5 THRESHOLD SETTINGThreshold setting procedure Threshold setting procedure For firmware version 1.3 or earlier Error Message 12. TROUBLESHOOTINGProblem SolutionProblem Error MessageSolution HD001 LF NUL and the print head has aProblem Error MessageSolution ProblemPage E PRINTED IN JAPAN EM1-33039E