Toshiba B-SX6T Series, EO1-33056D owner manual This parameter is to enable Dhcp, Dhcp Client ID

2. PRINTER SETUP

ENGLISH VERSION EO1-33056

2.8 Setting an Operating Environment

2.8.7IP Address Setting (TCP/IP) (Cont.)

NOTE:

Pressing the [PAUSE] key while “DHCP ON” is displayed allows you to set a DHCP client ID.

(5) DHCP

This parameter is to enable DHCP.

<7>IP ADDRESS DHCP

	[PAUSE]	[RESTART] or [FEED]
<7>IP ADDRESS			<7>IP ADDRESS
DHCP OFF			DHCP ON

NOTES:

1.Code used to enter a DHCP client ID is selectable between ASCII code (alphanumeric) and Hex code.

2.Set a character or value for each byte by using the

[RESTART] or [FEED] key.

[RESTART] key: Increment

[FEED] key: Decrement

3.Press the [PAUSE] key to enter the next byte. Repeat this until 16th byte is entered.

4.A DHCP ID can be used to check what IP address is assigned to which client on a DHCP server. If a DHCP ID is not assigned, MAC address of a network device (LAN card or LAN interface board) will be notified to the server as a DHCP ID instead.

A DHCP ID is a 16-byte character string. As “FFH” (hex. code) is recognized as a terminator, if the top byte of DHCP ID is “FFH”, it is considered that a DHCP ID is not assigned.

[PAUSE]

<7>IP ADDRESS DHCP CLIENT ID

(6) DHCP Client ID

This parameter is to set a DHCP client ID.

<7>IP ADDRESS DHCP CLIENT ID

[PAUSE]

[FEED] or [RESTART]

	MODE		ASCII	MODE HEX
	DHCP CLIENT ID			DHCP CLIENT ID
ASCII Code							Hex. Code
		[PAUSE]			[PAUSE]
	MODE		ASCII	4142434445464748
	ABCDEFGHIJKLMNOP			494A4B4C4D4E4F50
	Enter a character or a value for each of 1st byte to 16th
	byte sequentially using the [FEED] or [RESTART] key.
	[PAUSE]					[PAUSE]

E2-47