Toshiba FT-8801A 1, 2

BASIC OPERATION

Basics

OUT OF RANGE

During a call, as you begin to move too far from the base unit, the

noise increases. Then, you should move close to the base unit. If you

travel out-of-range, your call terminates.(See page 19 “Interference or

static”).

CALL WAITING

To use this feature, you must subscribe to the Call Waiting Service.

1When you hear a call-waiting tone during your conversation on the

phone, simply press .

2To return to the first caller, press again.

NOTE:

Pressing without receiving a Call Waiting signal may disconnect the

current caller.

HANDSET EARPIECE VOLUME SETTING

FLASH

To adjust the earpiece volume, press ( or ) during a call.

HANDSET RINGER VOLUME SETTING

To adjust the ringer volume, press ( or ) during standby

mode.

VOL/RING

REDIAL

Handset On The Base

1) Pick up the handset and press .

2) Listen for the dial tone.

3) Press .

REDIAL

TALK

Handset Off The Base

Press , then press .

TALK

REDIAL

FT-8801A.qxd 7/13/1 10:40 AM Page 18

Contents

Main GETTING STARTED: DO THIS FIRST! INTRODUCTION FEATURES TABLE OF CONTENTS Preparation Basics TABLE OF CONTENTS Caller ID/Call waiting Additional Information IMPORTANT SAFETY INSTRUCTIONS The RBRCTM Seal IMPORTANT SAFETY INSTRUCTIONS BATTERIES SAVE THESE INSTRUCTIONS HANDSET FT-8801A.qxd 7/13/1 10:40 AM Page 8 LOCATION OF CONTROLS SUPPLIED ACCESSORIES: Modular Line Cord Part # RC008231 Wall Mount Bracket Part # RC009245 / LOCATION OF CONTROLS BASE UNIT SETTING UP THE BASE UNIT (DESK TOP MOUNTING) AC ADAPTOR INFORMATION SETTING UP THE BASE UNIT (WALL MOUNTING) MOUNTING ON A STANDARD WALLPLATE: Insert the brackets tabs into the notches on the base. CHARGING THE BATTERYPACK 1 2 3 4 5 Page SETTING THE DIAL MODE 1 2 SETTING OR CANCELING THE AUTO TALK FUNCTION 1 2 3 SETTING OR CANCELING CALLER ID ON CALL WAITING 1 2 3 SETTING THE AREA CODE 1 2 4 5 MAKING A CALL RECEIVING A CALL NOTE: To delete a wrong number, press or , and . To delete all numbers, press and hold . () Before using the Handset, make sure to read the following instructions. 1 2 HANDSET EARPIECE VOLUME SETTING HANDSET RINGER VOLUME SETTING REDIAL 1 STORING NUMBERS 2 3 4 5 6 7 8 9 1 2 4 5 6 7 8 9 STEPS FOR ENTERING NAMES AND SPECIAL CHARACTERS 10 11 stored. 12 IF YOU MAKE A MISTAKE WHILE ENTERING A NAME DIALING A STORED NUMBER 1 2 3 4 5 a b ANSWERING A CALL WITH CALLER ID SERVICE 1 2 Page SEARCHING CALLER ID MEMORY 1 2 3 CALLING BACK FROM THE CALLER ID LIST 1 EDITING CALLER ID DATA 2 3 STORING TO SPEED-DIAL MEMORY 1 3 4 DELETING CALLER ID DATA DELETE INDIVIDUAL CALLER ID DATA: 1 3 4 DELETE ALL CALLER ID DATA: 1 3 4 CALL WAITING WITH CALLER ID SERVICE 1 2 TROUBLESHOOTING TROUBLESHOOTING PROBLEM SOLUTION WARRANTY/SERVICE SERVICE REQUIREMENTS IMPORTANT INSTRUCTIONS TO USERS FCC REQUIREMENTS WARRANTY/SERVICE TELEPHONE/TELEPHONE ANSWER MACHINE LIMITED WARRANTY How to Obtain Warranty Service In The Continental United States contact: www.toshiba.com/tacp In Hawaii contact: QUICK REFERENCE GUIDE Read the Owners Manual for details. / 3 Making a Call