INSTALLATION
SETTING UP THE BASE UNIT (WALL MOUNTING)
MOUNTING ON A STANDARD WALL PLATE:
Insert the bracket’s tabs into the notches on the base.
Preparation
Flip the hook tab over so the tab holds the handset.
Raise the antenna.
Telephone
Line Cord
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
•Route the cords through the guides.
•Place the base unit on the posts of the wall plate and push down until it is firmly seated.
NOTES:
•Do not use any outlet controlled by a wall switch.
•If you don’t have a standard wall plate, cut out the template on this page and use it to position two screws (minimum length of 13/8 inches) into the wall with the heads protruding about 1/4 inch.
CUT | CUT |
Wall mount template
IMPORTANT:
•Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone.
•Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard.
11
