LF410/LF600 LF410/LF602
About establishment environment
Do not store or install the flowmeter in:
•Places where there is direct sunlight.
•Places where excessive vibration or mechanical shock occurs.
•Places where high temperature or high humidity conditions obtain.
•Places where corrosive atmospheres obtain.
•Places submerged under water.
•Place where there is slop floor. To put the flowmeter temporarily on the floor, place it carefully with something, such as stopper, to support it so that the flowmeter will not topple over.
In places like the following places, there is the case that infrared switches do not function correctly. (If this is unavoidable, use an appropriate cover.
•Places where gets very bright light onto operation panel. (direct sunlight, reflection light of sunlight by windowpanes, diffused reflection light of strength etc.)
•Places where smoke and steam occur near.
•Places where a snow, ice or mud that may attached.
Ordering Information
1.When ordering the LF410 series flowmeters, refer to Tables 3 and 4 (Type Specification Codes). An entry must be made for each of the columns in each of these tables.
2.Fluid characteristics:
(1)Type of fluid to be measured and its characteristics
(2)Fluid temperature
(3)Fluid pressure
(4)Electrical conductivity of the fluid
3.Measuring range
4.I/O function setting
5.Ordering scope:
Flow calibration data: (required or not)
6.Other items
Specifications other than standard items
Consult Toshiba representative before ordering when choose materials of the wetting parts such as lining, electrodes, and grounding rings.
13
