Battery Installation, Battery Precautions, Feet | Toshiba MV13P3

REMOTE CONTROL

BATTERY INSTALLATION

1	Slide the battery compart-	2	Install two “AAA” batteries,
1	ment cover in the direction	2	paying attention to the
	of the arrow.		polarity diagram in the
			battery compartment.

BATTERY PRECAUTIONS

(CONTINUED)

3	Replace the compartment
3	cover.

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (Follow battery manufacturer’s directions).

EFFECTIVE DISTANCE OF THE REMOTE CONTROL

15 FEET

NOTES: • When there is an obstacle between the TV/VCR and the remote control, the remote control may not operate.

•When direct sunlight, an incandescent lamp, ﬂuorescent lamp or any other strong light shines on the Remote sensor of the TV/VCR, the remote operation may be unstable.

•When using the remote control, press the button at intervals of about 1 second to ensure the correct mode of operation.

10

5L80301C P10-19

10

20/4/04, 16:25

Image 12

Toshiba MV13P3 owner manual Battery Installation, Battery Precautions, Effective Distance of the Remote Control, Feet

Contents

TV/CABLE Mode Selection MV13P3 Risk of Electric Shock Do not Open Cleaning AccessoriesPower Source Grounding or Polarization Read Instructions POWER-CORD Protection Power LinesReplacement Parts Lightning Safety Check HeatNEC Section Features Table of Contents Safety Precautions When YOU Experience the Above ConditionsMoisture Condensation Moisture will Condense on the Unit in the Following Cases Power Source To USE AC PowerWider Hole and Blade AC Outlet Location of Controls Front RearDescription of Controls Front Remote Control Cursor Selects an item in the menuSpeed button Sets the tape speed for recording Battery Installation Battery PrecautionsEffective Distance of the Remote Control Feet Antenna Connections JackOhm matching transformer Antenna Jack Combiner UHF 300 ohm VHF 300 ohm For Subscribers to Basic Cable TV Service For Subscribers to Scrambled Cable TV ServiceCable TV Connections Starting Setup Enter Setting the Language Auto Clock Setting Auto Clock SettingAuto Clock Adjustment To SET Auto Clock to OFF Auto for automatic setting read EDS in the signal Press MENU. Press Bor a to select optionPress or to select Daylight Saving TIME, then press a Menu screen is cleared Manual Clock Setting Press Bor Ato setMonth, then press As in , then press Press Power Adjust the volume level byTV Operation Cable TV Channels Call MuteChannel + Mute Closed Caption Channel Return SleepSleep Closed Caption What is Closed CAPTIONING? Closed Captioning with a VCRTo View Closed Captions Cable TV chart To Memorize ChannelsTV/CABLE Selection Automatic Memory Tuning Then press aNumbers will remain red until auto memorizing is complete To ADD/DELETE Channels Channel selection Setting the V-CHIP To Register PasswordEnter the same password Using Direct channel To SET the V-CHIP Enter To use the TV after the TV is protected To Change Password To SET the on Timer Press B or Ato select ON/OFF TIMER, thenOn TIMER, then press a Option Press a To SET the OFF Timer Press Bor Ato selectOption Press a Picture Control Adjustments CancelSelection Pressing Adjusting the Picture Preference Mode Picture QualityPress B or a to select option PREFERENCE, then press a Press or to select the desired picture Automatic Power on and Play Loading and Unloading a Video CassetteLoading Unloading To Prevent Accidental Erasure To Record Again Tape Speed and Maximum PLAYBACK/RECORDING TimeSP Standard Play Playback To Start PlaybackStop To Stop Playback Digital Tracking Controls REWTo Rewind or Forward the Tape Rapidly FORWARD/REVERSE Picture Search Special Playback StopSkip Search PAUSE/STILL Over until the repeat mode is canceled To Watch a Tape RepeatedlyPress Bor Ato select on Recording a TV Program Recording and Viewing the Same TV Program Screen and the REC indicator will light To Stop Recording To Stop Recording TemporarilyPress Direct channel selection 0-9orCH + Ple Channel ONE-TOUCH Timer Recording OTR Press Direct channel Timer Recording Press or to select Timer REC SETPosition, then press Enter Press the or to select the program Timer REC indicator will light Speed as in stepPress Enter Steps 3 to 6 to set the second program Other Functions for the Timer Recording CancelTo Cancel a Program If the Program Program Using the Real Time Tape Counter To View the Counter DisplayDisplay the elapsed time Using Zero Return Before playback or recording, press000000 Press Zero Return TV Monitor To Monitor a TV ProgramIndex search Duplicating a Video Tape Connection to Another VCRConnection to Camcorder Reception Disturbances Problem and Troubleshooting Guide Check the following chart before requesting serviceSymptom Cause Possible Solution Power No power Symptom Cause Possible Solution Remote ControlDepressed To turn on the closed caption Recording Video Head Cleaning Video Head CleaningVideo Head Clogging Television Limited Ninety 90 Day Warranty Limited One 1 Year WarrantyLimited Two 2 Year Warranty of Picture Tube Rental Units How to Obtain Warranty Service Toll FreeContinental United States contact 04/04 U