Toshiba MW20FN3/R Second Audio Program SAP Stereo recording and playback, Listening to SAP

Other functions (VCR)

Second Audio Program (SAP)/ Stereo recording and playback

AUDIO SELECT 1-2

1-2

1-2

Second Audio Program (SAP) Stereo recording and playback

Your unit is fitted with a SAP broadcast system which enables you to switch to a Second Audio Program when viewing a se- lected channel.

This function applies only when the program is broadcast in multi-languages through the SAP broadcast system.

The VHS Hi-Fi audio system permits high fidelity recording of MTS STEREO TV broadcasts.

1 Press MENU. Press or to select “TV SETUP”, then press ENTER.

	M E N U
MENU	TIMER REC SET
	TV SETUP

When a MTS STEREO broadcast is received, “STEREO” will appear on the screen and the program can be viewed or recorded in ste- reo.

STEREO

ENTER	CH SETUP
	AUTO REPEAT ON OFF
SETUP	SYSTEM SETUP
	〈 / /ENTER/MENU〉

2 Press or to select “SAP”. Then press ENTER to select “ON”.

Then press MENU repeatedly until the menu screen is cleared.

	TV SETUP
MENU	V-CHIP SET
	ON/OFF TIMER
ENTER	PICTURE
	AUDIO
SETUP	SURROUND	ON	OFF
	STABLE SOUND	ON	OFF
	SAP	ON	OFF
〈	/ /ENTER/MENU〉

Listening to SAP

When the unit is turned on or a channel selection is made, make certain the letters “SAP” appears on the screen. This means that the “Second Audio Program” broadcast- ing is available.

STEREO SAP SAP

OR

Notes:

•When playing back a tape that is not recorded in Hi-Fi stereo mode, the audio will automatically be monaural.

•When listening to a VHS Hi-Fi video tape or MTS broadcast through the VHF/UHF jack (Audio/Video cord not connected), the sound will be monaural.

The Hi-Fi stereo recording proce- dure is the same as for normal recordings.

Note:

When using a CATV system, stereo TV programs may be transmitted over a mono cable channel. In this case “STEREO” will not appear and the sound will be in mono.

AUDIO

SELECT

Output selection

When viewing an MTS stereo TV program, or playing a prerecorded VHS Hi-Fi stereo videotape, press AUDIO SELECT to select how the audio will be heard through the speakers. Normally set to the Hi-Fi stereo position, this button can be set to the MONO position if the stereo broadcast or videotape audio is of poor quality. The “R” and “L” positions allow the audio from the Right or Left Hi-Fi channel to be heard over both TV speakers. This button has no effect when viewing a MONO videotape or TV program. Each time when you press the button, OUTPUT SELECTION display appears on the screen for several seconds. Refer to the chart below.

OUTPUT	SOUND HEARD ON BOTH
SELECTION	SPEAKERS
STEREO	STEREO
L ch	LEFT CHANNEL AUDIO
R ch	RIGHT CHANNEL AUDIO
MONO	MONO

46