Operating Basics
■Do not touch the laser lens or any portion of its surrounding casing as this could cause misalignment.
■Prevent foreign objects from entering the drive. Check the surface of the disc tray, especially the area behind the front edge of the disc tray, to make sure there are no such objects before closing the drive.
4.Press gently at the center of the disc until you feel it click into place. The disc should lie below the top of the spindle, flush with the spindle base.
5.Push the center of the disc tray to close it. Press gently until it locks into place.
If the disc is not seated properly when the disc tray is closed, the disc might be damaged. Also, the disc tray might not open fully when you press the eject button.
Figure 4-5 Closing the disc tray
Removing discs
To remove the disc, follow the steps as detailed below:
Do not press the eject button while the computer is accessing the media drive. Wait for the optical disc drive indicator to go out before you open the disc tray. Also, if the disc is spinning when you open the disc tray, wait for it to stop before you remove it.
1.To pop the disc tray partially open, press the eject button. Gently pull the disc tray out until it is fully opened.
When the disc tray pops open slightly, wait a moment to make sure the disc has stopped spinning before pulling the disc tray fully open.
2.The disc extends slightly over the sides of the disc tray so you can grasp it. Gently lift out the disc.
User’s Manual |
