Toshiba SD-260SA, SD-260SV, SD-260SY manual Loading batteries, Operating with the remote control

Models: SD-260SV SD-260SA

1 61
Download 61 pages 14.13 Kb
Page 14
Image 14
Loading batteries

Introduction

Loading batteries

1 Open the cover.

2 Insert batteries (R03/AAA size).

Make sure to match the + and – on the batteries to the marks inside the battery compartment.

Caution

• Never throw batteries into fire.

Notes

Be sure to use R03/AAA size batteries.

Dispose of batteries in a designated disposal area.

Attention should be drawn to the environmental aspects of battery disposal.

Do not mix different battery types or combine used batteries with new ones.

If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.

If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to prevent battery acid from leaking into the battery compartment.

Operating with the remote control

Point the remote control at the remote sensor and press the buttons.

Distance: About 7 m (23 feet) from the front of the remote sensor

Angle: About 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the DVD video player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD video player via the remote control.

Notes on the remote control

Direct the remote control at the remote sensor of the DVD video player.

When using the remote control, press the buttons at intervals of about 1 second to ensure the correct mode of operation.

Do not drop or give the remote control a shock.

Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Do not open the remote control.

14

Page 14
Image 14
Toshiba SD-260SA Loading batteries, Operating with the remote control, Open the cover 2 Insert batteries R03/AAA size