Other functions
Sleep timer | Mute |
You can set the DVD receiver to turn off automati- cally at a specified time.
Press SLEEP to set the desired sleep time.
The SLEEP indicator and sleep time appears on the display window.
Each time you press SLEEP, the setting changes in the following order.
SLEEP
120 110 100 ... 30 20 10 0(off)
Notes:
•After the sleep timer is programmed, the remaining timer appears briefly every ten minutes on the display window.
•To confirm the sleep timer setting, press SLEEP.
Press MUTE to mute your unit.
You can mute your unit in order, for example, to answer the telephone, “MUTE” indicator appears on the display window.
Using headphone socket
Connect a stereo headphone plug (ø 3.5mm) into the HEADPHONE socket on the rear panel.
The speakers are automatically disconnected when you plug in the headphones (not supplied).
Notes:
•When you use the headphones, keep the volume at a moderate level. If you use the headphones continuously with high volume sound, it may cause hearing damage.
•In using the headphones, Tone/Bass Boost/Surround settings do not effect.
Dimmer
This function will change the brightness of the display window and the control buttons on the front panel during
Press the DIMMER to dim the display window. To cancel the Dimmer function, press DIMMER again.
Press and hold DIMMER for 3 seconds to dim the control buttons.
To cancel the Dimmer function, press and hold DIMMER for 3 seconds again.
Selecting input source
You can use VCRs or other units connected to the LINE IN 1 or LINE IN 2 connectors.
Press INPUT SELECT repeatedly on the remote control to select the desired input source.
Note:
The Optical/Coaxial input function is available only when the other unit’s Sampling Frequency is as follows.
PCM: | 32KHz, 44.1KHz, 48KHz |
Dolby Digital: | 48KHz |
DTS: | 44.1KHz, 48KHz |
Depending on the setting or the combination of the other unit, the sound may not be played correctly.
Screen saver
The screen saver operates when you leave the unit in DVD stop mode for about five minutes.
38