Controlling Your Cable Box/DSS® Satellite Receiver
Setting Cable Box/DSS® Satellite
Receiver Control Codes
1.Press CABLE BOX to set the remote control operating your Cable box/DSS® Satellite
Receiver.
2. While holding down PROGRAM button, enter the two digits of your Cable box/DSS® Satellite Receiver Brand Code (listed on page 39) using number buttons.
3. Release PROGRAM.
Point the remote control at your Cable box/DSS® satel- lite Receiver and use each button listed below to make sure that your Cable box/DSS® satellite receiver is oper- ated correctly.
By pressing | You can |
POWER | Turn the Cable box/DSS® satellite |
| receiver on or off. |
|
|
CH/TRK +/– | To select Cable box/DSS® satellite |
| receiver channels in the upper or |
| lower direction, (Not applicable to |
| some brands of Cable box/DSS® |
| satellite Receiver.) |
|
|
Number buttons | To select desired channels to |
| record. |
|
|
ENTER | To use for the Cable box’s Enter |
| Key. |
|
|
(Some cable boxes require you to use 100 button as the enter button.)
Important
Some Cable box/DSS® satellite receiver may not respond to all the operations above, or may not be operated at all with this remote control. In this case, operate them with its own remote control.
Note
For some brands, several control codes (brand codes) are allocated. Try each of them until the but- tons work on your TV.
If you replace the remote control’s batteries, set the brand code again.
CABLE BOX
POWER
PROGRAM
Number buttons
100
CH/TRK
ENTER
38
