Toshiba SD-V395KC owner manual Temporary cancel the rating level by DVD disc

Notes:
• The parental control level is equivalent to the following
USA movie ratings.
Level 1: G	Level 5:
Level 2:	Level 6: R
Level 3: PG	Level 7: NC-17
Level 4: PG-13	Level 8:

The parental control levels for other countries/area than U.S. are included for future use. Check the appropriate parental control level when you buy a DVD video disc equipped with the parental control feature in the future.

• Depending on the discs, the unit cannot limit playback.

• Some discs may not be encoded with specific rating level information though its disc jacket says “adult.” For those discs, the age restriction will not work.

• The password is required every time when you change the parental level.

• If you input a wrong number, press CLEAR.

■Set the new password

1)Press ▲ or ▼ to select “Password”, then press ENTER. “Enter Current Password” screen will appear.

2)Press Number buttons (0–9)to input the current password (If the password has not been set yet after you purchase this unit, it is “0000”).

3)Then press ENTER. “Enter New Password” screen will appear. Press Number buttons (0–9)to input the new password.

4)Press ENTER. Now your new password has been set. Be sure to remember this number!

If you forget the password.

1)Press OPEN/CLOSE to open the disc tray.

2)Remove the disc.

3)Press OPEN/CLOSE again to close the disc tray. “No Disc” appears on the screen.

4)While holding 7 down on the remote control and at the same time press STOP on the front panel. “Password Clear” appears on the screen. Now the password has been returned to the initial value (“0000”).

■ Output

You can select the video output signal of the DVD video player to the TV from “Interlace” or “Progressive”.

Interlace:

Select when connecting to a composite TV or a TV equipped with component video inputs but progressive scan is not compatible.

Progressive:

Select when connecting to a TV equipped with component video inputs and progressive scan compatible.

Warning:

Once “Progressive” is selected when connecting to a TV progressive scan incompatible, no image will be seen on the video display.

In this case, you must reset the unit by pressing STOP, on the front panel for five seconds. The video output will be restored to “Interlace” setting, and a picture will once again be seen on a conventional analog display.

Notes:

• Some discs may not be played back with the progressive scanning mode correctly because of the disc characteristics or recording condition.

• Once Progressive scan on, S-video output is disabled.

■ DivX(R) VOD

In order to play DivX® VOD (Video On Demand) content on this unit, you first need to register the unit with your DivX® VOD content provider.You do this by generating a DivX® VOD registration code, which you submit to your provider.

Press ▲ or ▼ to select “DivX(R) VOD”. Then press ENTER.Your 8-character registration code is displayed. Make a note of the code as you will need it when you register with a DivX® VOD provider. Then press ENTER.

Note:

If each setup (pages 41 ~ 43 ) has completed, the unit can always work under the same condition (especially with DVD discs).

Each setup will be retained in the memory even if you turn the power off.

Temporary cancel the rating level by DVD disc

Depending on the DVD disc, the disc may try to temporarily cancel the rating level that you have set.

It is up to you to decide whether to cancel the rating level or not.

Temporary cancel the rating DVD level by DVD disc

1 Load a DVD disc and press PLAY or OPEN/CLOSE on the unit 32 .

2 If the DVD disc has been designed to temporarily cancel the Rating level, the screen which follows the “Reading” screen will change, depending on which disc is played. If you select “Yes” with the ENTER key, password input screen will then appear.

3 Enter the password with Number buttons (0–9). Then press ENTER.

To exit from the entry, press RETURN.

4 Playbackcorrect. will commence if the entered password was

Note:

This temporary cancellation of rating level will be kept until the disc is ejected.

When the disc is ejected, the original rating level will be set again automatically.

Function setup (DVD)

43

2K60121A.indb 43

1/12/2007 3:50:20 PM