2.4Tool Wiring and Piping
This paragraph describes the wiring and air piping for the tool.
2.4.1Tool Wiring
For the tool wiring, see the descriptions on tool wiring (Para. 4.2.2) included in the Transportation and Installation Manual.
For the wiring, be sure to use the connector at the lower side of arm 2.
2.4.2Tool Air Piping
In all, two (2) air pipelines (outer dia. 6 mm × inner dia. 4 mm) are available for the tool. Figures 2.5 and 2.6 show the joint locations of these pipelines.
Lower side of arm 2 | Rear side of fixed base |
Figure 2.5 Location of
Lower side of arm 2 | Rear side of fixed base |
Figure 2.6 Location of
STE 58792
– 10 –